Medtronic CareLink Guia do Utilizador descarregar pdf (Página 18)

16 I CareLink Personal Software Set Up

Set Up

Uploading Your Meter to a Mac

UPLOADING YOUR METER TO A MAC

If you are using a Mac, there are a few additional steps to follow to set up your computer to upload

your compatible blood glucose meter.

NOTE Make sure to start up your Mac in 32-bit kernel mode whenever you want to upload your

meter. By default, most Mac computers start in 32-bit kernel mode.

STEP 1:

Get a serial cable from the meter manufacturer. You will need a

serial cable because most meter manufacturers that provide USB

cables do not provide Mac support.

STEP 2:

Get a USB-to-serial adapter that is compatible with your Mac

operating system. You will need a USB-to-serial adapter because

Mac computers do not have serial ports.

STEP 3:

Go to www.medtronicdiabetes.com/carelinksetup and click on the link for Setting Up & Uploading

on a MAC. Next, click on Uploading Your Meter & Multiple Devices. This will provide you with links

to any drivers you will need to install to use your USB-to-serial adapter for the MAC operating system

on your computer.

STEP 4:

When prompted, enter your Mac username and password. The username must be the Administrator

on your computer.

STEP 5:

Restart your computer when instructed.

STEP 6:

Plug the USB adapter for your meter cable into your USB port. Plug your meter serial cable into

the USB adapter.

NOTE The rst time you connect the cable after installing the driver, you may see a screen

that tells you that a new network interface has been detected. Do the following:

•

Click Network Preferences. The Network window is displayed.

•

Click Apply.

•

Close the Network window.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Sem comentários

Medtronic CareLink Guia do Utilizador Página 18