Medtronic Paradigm Link Guia do Utilizador descarregar pdf (Página 134)

Example

You set your High Snooze to 15 minutes. You receive an alert at 1:00 pm and immediately clear it. However,

the high glucose condition that caused the alert still exists, so you will receive a second alert at 1:15 pm, 15

minutes after you cleared the first alert. If you immediately clear the alert again, then the alert will repeat

at 1:30 pm and continue to repeat every 15 minutes until you resolve the condition that caused the alert.

(This example also applies to the Low Snooze.)

ಗ

To set up your High Snooze:

ಘ

Make sure the EDIT SETTINGS screen is open.

Main > Sensor > Sensor Setup > Edit Settings

ಘ

Select High Snooze, then press ACT. The SET HIGH SNOOZE screen flashes the default High Snooze time

of 1 hour (1:00).

ಘ

Select your High Snooze time. The time must be between five minutes (0:05) and three hours (3:00).

ಘ

Press ACT. The EDIT SETTINGS screen shows the High Snooze time set.

You are now ready to set up your Low Glucose limit.

Low Glucose Alert

Your Low Glucose alert must be turned on if you want your pump to alert when the sensor glucose

measurement reaches or goes below your set Low Glucose limit.

ಗ

To turn on your Low Glucose alert, and to set the Low Glucose limit:

ಘ

Make sure the EDIT SETTINGS screen is open.

Main > Sensor > Sensor Setup > Edit Settings

ಘ

Select Low Glucose, then press ACT.

ಘ

Select On, then press ACT. The SET LOW GLUCOSE screen flashes the default Low Glucose limit of 50

mg/dL (2.8 mmol/L).

ಘ

Select your Low Glucose limit between 40–390 mg/dL (2.2–21.6 mmol/L). Your Low Glucose limit must

be at least 10 mg/dL (0.6 mmol/L) below your High Glucose limit.

ಘ

Press ACT. The EDIT SETTINGS screen shows the Low Glucose value set. You are now ready to set up your

Low Snooze.

Sensor features

115

ಘChapter 8

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 261 262

Sem comentários

Medtronic Paradigm Link Guia do Utilizador Página 134