Medtronic Paradigm Link Guia do Utilizador descarregar pdf (Página 139)

Charging the transmitter

Before using the transmitter for the first time, you must fully charge the transmitter battery, which may

take up to eight hours. It is recommended to recharge the transmitter after each sensor use. If you choose

to recharge the transmitter after each sensor use, the charging time will be less than 20 minutes. A fully

charged transmitter battery will work more than 14 days without recharging. After 14 days of use, the

transmitter will fully recharge in less than two hours.

ಘ

If a green light on the transmitter is lit or flashing, do not connect it to the charger. The transmitter will

not charge with its green light on. Wait for the green light to turn off, then connect the transmitter to

the charger.

ಘ

Connect the transmitter to the charger by lining it up, flat side down, with

the charger. Push the two components together fully. Always allow at least

one minute before disconnecting the transmitter from the charger or the

transmitter may not work properly. If you disconnect the transmitter before

one minute, reconnect it to the charger for at least one minute.

ಘ

Within 10 seconds after the transmitter is connected, a green light on the charger will flash for one to

two seconds as the charger powers on. For the rest of the charging time, the charger's green light will

flash in a continuing pattern of four flashes, pause, four flashes, pause.

green light

Sensor features

120

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 261 262

Sem comentários

Medtronic Paradigm Link Guia do Utilizador Página 139