Medtronic iPro2 Guia do Utilizador descarregar pdf (Página 11)

CGMS

iPro

Continuous Glucose Recorder User Guide 9

Charger

WARNING: Always clean the digital recorder after removing it from the patient

and before attaching it to the charger. See the cleaning instructions on page 20.

The digital recorder contains a non-replaceable, rechargeable battery that you can

recharge as needed with the charger. The charger has a green light that shows the

charging status and a red light that indicates any problems during charging. If you see a

red light, see the Troubleshooting section on page 18. The charger needs one AAA

battery, size E92, type LR03, to operate. A new AAA battery contains enough power to

recharge the digital recorder more than 40 times.

Installing a new charger battery

1. Remove the charger battery cap by turning it

counter-clockwise 1/4 turn using a coin in the

groove of the cap.

2. Insert a new AAA battery with the flat (-) end

first. Make sure that you align the small bumps

on the battery cap with the small notches in the

charger’s battery opening. Push in the cap all

the way using a coin. Turn the cap clockwise 1/4

turn to close.

3. If the battery is installed incorrectly or is low, the charger will not work. Repeat the

steps above using a new battery.

Charging the digital recorder

Before using the digital recorder for the first time, you must fully charge the digital

recorder battery which may take up to eight hours. It is recommended to recharge the

digital recorder after each glucose sensor use. If you choose to recharge the digital

recorder after a 3-day glucose sensor use, the charging time will be less than 20

minutes.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Sem comentários

Medtronic iPro2 Guia do Utilizador Página 11