Medtronic iPro2 Guia do Utilizador descarregar pdf (Página 17)

CGMS

iPro

Continuous Glucose Recorder User Guide 15

5. When connecting the digital recorder to the glucose sensor, touch the inserted glucose

sensor at the back of the assembly to prevent movement.

6. Hold the digital recorder as shown. Line up the

two notches on both sides with the flexible side

arms of the glucose sensor. The digital

recorder flat side with the label should face

the skin.

7. Slide the digital recorder onto the glucose

sensor. Push it in firmly until the flexible side

arms of the glucose sensor snap into the

notches on both sides of the digital recorder. In

the next 20 seconds the digital recorder will

flash green for about 10 seconds. This indicates

that the digital recorder is properly connected to a sensor and that it has enough

battery power to work for at least three days.

8. If the digital recorder light does not flash, disconnect it from the glucose sensor. Wait

for at least one minute and then reconnect. If the digital recorder light still does not

flash, charge the digital recorder.

9. After the digital recorder light flashes green, you

will be prompted by Solutions iPro to swipe the wand

across the digital recorder. Please refer to Using the

CGMS iPro Recorder and iPro Wand, on page 13, for

correct swiping technique.

10. Solutions CGMS iPro will tell you if you have

successfully started communication or if you need to

repeat the start process.

11. After the digital recorder is successfully initialized

by Solutions CGMS iPro, the Solutions software will

prompt you to apply the recommended occlusive dressing over the digital recorder and

the glucose sensor.

Sensor

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Sem comentários

Medtronic iPro2 Guia do Utilizador Página 17