Medtronic Revel Guia do Utilizador descarregar pdf (Página 132)

4 Select your Cal Reminder time between 5 minutes (0:05) and 6 hours (6:00).

5 Press ACT. The EDIT SETTINGS screen shows the Cal Reminder time you selected. You are now ready

to enter your transmitter ID number.

Entering the transmitter ID

The transmitter ID (serial number) starts with 2 and is found on the flat side of your transmitter. You must

enter the transmitter ID so that the transmitter and the pump can communicate with each other.

Write the Transmitter ID of the transmitter you are using here: __________________.

1 Make sure the EDIT SETTINGS screen is open.

Main > Sensor > Edit Settings

2 Select Transmtr ID, then press ACT. The SET TRANSMITTER ID screen appears. The screen shows seven

dashes for the Transmitter ID, the first of which (on the left) is flashing.

3 Select the first number of the Transmitter ID (the number on the screen must

match the first number of the Transmitter ID). The transmitter ID is located on

the transmitter label, as shown.

MEDTRONIC MINIMED

MiniLink Transmitter

REF MMT-7703XX

SN GT2XXXXXXM

FCC D: OH27703

IC: 3458-7703

1234

IPX8

SN GT2XXXXXXM

4 Press ACT. The second dash flashes.

5 Select the next number of the Transmitter ID, then press ACT.

6 Repeat step 5 until all seven digits of the Transmitter ID have been selected.

7 A message shows that the Transmitter ID has been changed. After about 30 seconds, the EDIT

SETTINGS screen appears. It shows the Transmitter ID you entered.

You are now ready to set up the Weak Signal.

Setting up the Weak Signal feature

The Weak Signal feature allows you to determine how quickly you will receive a Weak Signal alert when

there is no communication between the transmitter and the pump. For example, if you set the Weak

Signal value to 30 minutes, you will receive a Weak Signal alert 30 minutes after loss of communication.

To set up the Weak Signal feature:

1 Make sure the EDIT SETTINGS screen is open.

Sensor features 111

Chapter 7

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 264 265

Sem comentários

Medtronic Revel Guia do Utilizador Página 132